deleted draining period and amount from config file as this does not work like i thought it would

controller/config/copy__init__.py.example

@@ -12,8 +12,6 @@ GPIO_PIN_OUT_VALVE = 21 # BCM
 GPIO_PIN_IN_VALVE = 18 # BCM
 START_PUMPING_AT = 'TANKLEVEL4'
 STOP_PUMPING_AT = 'TANKFULL'
-DRAINING_PERIOD_AMOUNT = 40
-DRAINING_PERIOD_UNIT = 'minutes'
 API_BASE_URL = 'http://agrar.zoblak.com/api/v1.0'
 CONTROLLER_ID = '120' # every controller must have a different one
 STATE_FILE = '/var/run/controller_state'

controller/sensors.py

@@ -35,8 +35,6 @@ print 'Bacva puna: {}'.format(tankFull)
 SENSOR_TYPE = Adafruit_DHT.DHT11
 controller_id = config.CONTROLLER_ID
 owner = "Controller: %s" % controller_id
-drainingPeriodAmount = config.DRAINING_PERIOD_AMOUNT
-drainingPeriodUnit = config.DRAINING_PERIOD_UNIT
 startPumpingAt = config.START_PUMPING_AT
 stopPumpingAt = config.STOP_PUMPING_AT
 
@@ -53,7 +51,7 @@ humidity, temperature = Adafruit_DHT.read_retry(SENSOR_TYPE, config.GPIO_PIN_DHT
 # If this happens try again!
 if temperature is not None and humidity is not None:
     response = requests.post(config.SENSORDATA_URL, json={"owner": owner, "temperatureValue": temperature, "humidityValue":humidity, "tankLevel0": "1" if tankLevel0 else "0","tankLevel1": "1" if tankLevel1 else "0","tankLevel2": "1" if tankLevel2 else "0","tankLevel3": "1" if tankLevel3 else "0", "tankLevel4": "1" if tankLevel4 else "0", "tankFull": "1" if tankFull else "0",
-    "startPumpingAt": startPumpingAt,"stopPumpingAt": stopPumpingAt,"drainingPeriodAmount":drainingPeriodAmount,"drainingPeriodUnit":drainingPeriodUnit,"controllerId": controller_id
+    "startPumpingAt": startPumpingAt,"stopPumpingAt": stopPumpingAt,"controllerId": controller_id
     })
     print 'Temp={0:0.1f}*C'.format(temperature)
     print 'Humidity={0:0.1f}%'.format(humidity)